LNEYA Enfriadoras industriales Fabricante Proveedor
Fault Hint of Cryogenic Chiller Refrigeration System
1. Pressure should be high and exhaust should be total. There may be heat dissipation problems.
When the high and low pressure of the system are higher than normal, there is usually air or excessive refrigerant in the system. At this time, we need to re-vacuum, and then add a proper amount of refrigerant to solve this problem. But there are also bad heat dissipation, especially when the ambient temperature is high, and the heat dissipation is often poor. The causes of failure are usually blockage of radiator, dirt and dirt, insufficient speed of cooling fan, etc.
2. If the pressure is doubled low, the refrigerant will be lost, otherwise the system will be shut down.
When both high and low pressures are low, there are two possibilities:
(1) When the system is blocked, the blocked part will produce throttling, and the throttling part will have obvious temperature difference, so the problem can be found manually.
(2) Refrigerant leakage results in insufficient refrigerant, which is a common phenomenon. At this time, the cryogenic water cooler detector must be used to find the leakage components and repair them.
3. Replace compressors with low pressure, high pressure.
When the pressure gauge of cryogenic chiller detects that the low pressure of cryogenic chiller system is higher than normal and the high pressure is lower than normal, the cooling effect of cryogenic chiller can never reach the normal effect. The reason is probably the wear of cryogenic chiller pumps, resulting in power decline. At this time, it often needs to replace the compressor to solve this problem.
4. When there is water vapor in the shaking table system, it must be evacuated more thoroughly.
Cuando el cryogenic refrigeration system works the system will have water if the instrument pointer keeps shaking. In order to solve this problem, it is usually necessary to re-vacuum. Pumping time shall not be less than 15 minutes. If necessary, it needs to change dry bottles to completely drain water from the system.
El prev: What Industries Can Low Temp Chillers Help?El siguiente: Types of Environmental Tests
Recomendaciones relacionadas
-
How to choose a laboratory deionized water chiller?
1151Pure water usually refers to water that has been treated to remove impurities, ions, organic matter, etc. Common examples include distilled water, reverse osmosis water, and deionized water. Deionized water has low conductivity due to t...
Ver detalles -
-
Battery-specific temperature cycle test chamber Chiller tips
1029With the rapid development of the economy, the new energy automobile industry has also achieved rapid development, and the requirements of the battery industry are also getting higher and higher. In order to adapt to related industries, LNEYA has ...
Ver detalles -
Selection of heat transfer oil for the refrigeration and heating system of the reactor
1105In the chemical industry, the reactor is a commonly used container, and temperature control is the main quantity to be controlled. The heating and refrigeration cycle equipment of the reactor is an important factor to ensure product quality. The r...
Ver detalles
