The ice water flow required for a set of plastic moulds is directly related to the heat taken away by the moulds and the temperature difference between the ice water entering and leaving the moulds. For example, to take the heat of 6480 kcal/h from the die, if the temperature difference is 3 C, what is the minimum flow rate needed? Ice flow Q = 6480_3_60 = 36 (l/min).

El ablandamiento del agua también es un problema importante en el proceso de utilización de enfriadoras. También es necesario observar continuamente el valor de pH del agua. El valor óptimo de pH debe ser igual a 7. Un valor de pH superior a 7 provocará una corrosión terrible. Si no se toman medidas, se formarán incrustaciones en el evaporador y la matriz, que desempeñarán un papel aislante, y el efecto de conversión de energía se reducirá 30% en casos graves. Evidentemente, esto exige tener en cuenta el reblandecimiento de...
The most effective method is to configure an electronic hard water softener in the system, which is designed and manufactured separately from the exchange principle. Softeners of different specifications can be configured according to different flow rates, which can be directly connected to the circulating water pipeline.

Generally, the cost of water treatment softener is not too high, and a certain proportion of scale removal agent can be added to the periodic circulation system. Generally, when the injection moulds are cooled and the pressure of ice water is 0.1-0.2 mpa, the requirements can be met. When the pressure requirement is higher than 0.2 mpa, it is necessary to plan separately in order to use the corresponding pressure from the pump to meet the need of water supply.
We are a top chiller manufacturer. Welcome to buy our products.